Hatches selection guide


 

RangeFeaturesLidLower frameLocation areas
Slim 6Very flat profile, sleek design
Opening at 90° by jack
ExtrusionExtrusionIIa, III, IV
Slim 6 RacingVery flat profil, sleek design
Opening at 180°
ExtrusionExtrusionIIa, III, IV
OpalFlat profile
Opening by stay
ExtrusionExtrusionIIa, III, IV
Opal FlushVery flat profile, sleek design, sturdy
Opening by stay
AcrylicExtrusionIIa, III, IV
CristalMedium profile, very resistant
Opening by stay
CastingExtrusionIIa, III, IV
TraditionHigh profile, extremely sturdy
Outside opening by friction
CastingCastingIIa, III, IV
IntegrationFlat profile, light and sturdy
Outside opening by friction
AcrylicCastingIIa, III, IV
Escape hatchesMedium profile, very wear-resistant
Indoor and outdoor opening
CastingCastingI, II, III, IV

* according to the sizes

 

Appliance location areas according to European standards 94/25/EC dated June 16th 1996 :

Area I : Hull above waterline
Area IIa : Deck, coachroof, cockpit, transom
Area IIb : Area from the hull sides not belonging to the area I
Area III : Superstructure, deck and cockpit
Area IV : Cockpit sides, rear faces of superstructure, deck and cockpit

 

CE areas

 


 

Accessories and spare parts Back to hatches Slim 6 range

Comments are closed